Ashtray
1993-1997 Honda Del Sol
Description
This is a printable ashtray, print it upright using support so the top gets nice and clean. use any material as long as you dont put burning cigs against pla. lmao Also fits original spring, place it back and it wont shove of the design of put on correctly, it will last you long probably, the spring can also be glued on the ashtray so it stays in place, whatever you desire NOTE: pivots need to filed down a bit and use some persuasion to fit the ashtray in the led, bend the lid open a bit while pushing the ashtray in between If you dont have original springs anymore, search for small latch springs and bend them to the original spring design
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is a printable ashtray, print it upright using support so the top gets nice and clean. use any material as long as you dont put burning cigs against pla. lmao Also fits original spring, place it back and it wont shove of the design of put on correctly, it will last you long probably, the spring can also be glued on the ashtray so it stays in place, whatever you desire NOTE: pivots need to filed down a bit and use some persuasion to fit the ashtray in the led, bend the lid open a bit while pushing the ashtray in between If you dont have original springs anymore, search for small latch springs and bend them to the original spring design
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed