Manual Window Crank Knob
1993 Jeep Cherokee XJ
Description
I have a 93 jeep cherokee and my manual window crank knob kept breaking, so i made a version of it and printed it out. i ran this at 25% infill and it seems to be holding up pretty well. I didn't put the hole or the x slot in because it makes it too weak and breaks right away. This one is solid and with a bit of force it goes right through and locks in place. I have to convert to mm in Simplify 3D and the overall height on Z is 27.94mm and X and Y are 26.66mm. Update: I forgot about the scaling issue, the new STL should have the proper scale when it is imported now.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I have a 93 jeep cherokee and my manual window crank knob kept breaking, so i made a version of it and printed it out. i ran this at 25% infill and it seems to be holding up pretty well. I didn't put the hole or the x slot in because it makes it too weak and breaks right away. This one is solid and with a bit of force it goes right through and locks in place. I have to convert to mm in Simplify 3D and the overall height on Z is 27.94mm and X and Y are 26.66mm. Update: I forgot about the scaling issue, the new STL should have the proper scale when it is imported now.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed