Rocker Switch Holder
1994-2000 Toyota Rav4 XA10
Description
Rocker Switch holder created for Toyota RAV4 1994-2000 (XA10), to replace the original without damaging it. Can likely be used for other Toyotas in the same age range. Used for hlding a rocker switch for controlling LED spot-lights, winch, etc. Important dimesions: Holder Blank: 42.5 x 24.5mm (Toyota Part) Switch: 19.5 x 12.5mm Switch I used: https://www.automarine.co.za/rocker-switches/5566-rocker-switch-blue-mini.html?sfdr_ptcid=43178_617_684616428&sfdr_hash=5eb1eef555720846d0650b797a3e3909 Here is the source for the design which you can modify the parameters of to fit your switch: https://cad.onshape.com/documents/1245b9ca769e6a02c4775b9c/w/de9cc3d46b3da11500259323/e/2cd1a716249528c5a5c47bf1 Parameters to change: height_switch & width_switch Printing: I found laying to the side was the best for strength in the moving clip parts which take a bit of strain when inserted. The layers create a wood like grain effect on the front of the holders face
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Rocker Switch holder created for Toyota RAV4 1994-2000 (XA10), to replace the original without damaging it. Can likely be used for other Toyotas in the same age range. Used for hlding a rocker switch for controlling LED spot-lights, winch, etc. Important dimesions: Holder Blank: 42.5 x 24.5mm (Toyota Part) Switch: 19.5 x 12.5mm Switch I used: https://www.automarine.co.za/rocker-switches/5566-rocker-switch-blue-mini.html?sfdr_ptcid=43178_617_684616428&sfdr_hash=5eb1eef555720846d0650b797a3e3909 Here is the source for the design which you can modify the parameters of to fit your switch: https://cad.onshape.com/documents/1245b9ca769e6a02c4775b9c/w/de9cc3d46b3da11500259323/e/2cd1a716249528c5a5c47bf1 Parameters to change: height_switch & width_switch Printing: I found laying to the side was the best for strength in the moving clip parts which take a bit of strain when inserted. The layers create a wood like grain effect on the front of the holders face
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed