Sunroof Motor Cover
1995 Bmw 3 Series E36 (Coupe)
Description
Adjusted the radius of the rounded corners to fit better Added two extra clips, to help keep sides of the panel in place (I already broke one, while attaching the panel for the 4th time) Made the switch hole wider, it was ~3mm narrower, than the switch mount requires (although I used window switch mount) Removed the microphone mount hole Printed in PC/PBT : buildplate touching supports, no cooling I am not sure if it would survive in PETG, since thin parts under load tends to deform inside the car in a hot weather (Tested this with the PETG snap in vent phone mount, the design is now improved tho!) Installed in '95 E36 coupe
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Adjusted the radius of the rounded corners to fit better Added two extra clips, to help keep sides of the panel in place (I already broke one, while attaching the panel for the 4th time) Made the switch hole wider, it was ~3mm narrower, than the switch mount requires (although I used window switch mount) Removed the microphone mount hole Printed in PC/PBT : buildplate touching supports, no cooling I am not sure if it would survive in PETG, since thin parts under load tends to deform inside the car in a hot weather (Tested this with the PETG snap in vent phone mount, the design is now improved tho!) Installed in '95 E36 coupe
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed