Ash Tray Repair Parts
1995 Ford F-150 OBS (XL)
Description
These are replacement parts that are commonly (at least I assume since my sister and I were both in need) lost/broken on OBS ford trucks. Tested on '95 F150 XL. The side rails have been modified from the original design to make printing easier, the springs super glue in from the back side. The clip take a 5/8" long wood screw to keep it from sliding out of position. The load is actually taken on the ridged of the original ABS ash tray component. Recommend printing in ABS. PLA will not last in a hot vehicle.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
These are replacement parts that are commonly (at least I assume since my sister and I were both in need) lost/broken on OBS ford trucks. Tested on '95 F150 XL. The side rails have been modified from the original design to make printing easier, the springs super glue in from the back side. The clip take a 5/8" long wood screw to keep it from sliding out of position. The load is actually taken on the ridged of the original ABS ash tray component. Recommend printing in ABS. PLA will not last in a hot vehicle.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed