Fuel Cap Holder
1996 Honda Civic Del Sol
Description
Tested on Honda Civic del sol 1996 Works maybe for other cars too, but only tested with this car. Printed with Anycubic Kobra (1) in 32 mins with 0.38mm Layer Height and 0.8mm Line Width (because i needed it fast) Better Print it with 0.2 Layer Height to look better Material PLA, but I recommend ABS! (because sunlight heat...) Support needed! It should hold good without tape but better add a bit of double sided tape.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Tested on Honda Civic del sol 1996 Works maybe for other cars too, but only tested with this car. Printed with Anycubic Kobra (1) in 32 mins with 0.38mm Layer Height and 0.8mm Line Width (because i needed it fast) Better Print it with 0.2 Layer Height to look better Material PLA, but I recommend ABS! (because sunlight heat...) Support needed! It should hold good without tape but better add a bit of double sided tape.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed