License Plate Nut Clip
1996 Nissan 240sx S14
May 7, 2026
Use the built-in measurement tool to verify fit before downloading or ordering.
Description
Recently purchased a 1996 240sx and one of the two license plate clip on nut holders was broken. Looked around and didn't find anything so whipped this up in about 15 minutes in Fusion 360. Met my needs and liked it so much I printed two so they matched. Currently is using the 2 M6 Nuts from the original clips just pushed into the recess.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Loading pricing...
Use the built-in measurement tool to verify fit before downloading or ordering.
Part Description
Recently purchased a 1996 240sx and one of the two license plate clip on nut holders was broken. Looked around and didn't find anything so whipped this up in about 15 minutes in Fusion 360. Met my needs and liked it so much I printed two so they matched. Currently is using the 2 M6 Nuts from the original clips just pushed into the recess.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed