Dash Vent Friction Shim
1996-2002 Toyota 4runner 3rd Gen
Description
The dash vents in my 1998 Toyota 4runner started to wobble and wouldn't hold their positions, so this is the piece that broke and was printed. I printed mine out of PLA and they have not had any troubles working with the heater or the AC on. You might need to shave down the inside hole with a knife to make it fit snuggly, and I put the shim onto the car and then inserted the vents on top of it.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
The dash vents in my 1998 Toyota 4runner started to wobble and wouldn't hold their positions, so this is the piece that broke and was printed. I printed mine out of PLA and they have not had any troubles working with the heater or the AC on. You might need to shave down the inside hole with a knife to make it fit snuggly, and I put the shim onto the car and then inserted the vents on top of it.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed