Fishing Rod Holder
1996-2002 Toyota 4runner 3rd Gen
Description
Use a 27" piece of 1/2" PVC pipe to bridge the two side rear mounts. Holes are for #8 5/8" length countersunk head sheetmetal screws (They work okay in plastic). For the forward mounts, just trim the headliner trim of the sunroof for the width of the mount (not shown). If you don't have a sunroof, use a bungee cord between the two rear pass "oh sh*t" handles. If you have light action trout or fly rods, the bungee cord maybe necessary as well as the forward hooks. I'm not sure how much weight the snaps for the rear trim can hold, so I would not recommend putting in fully equipped ocean setups.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Use a 27" piece of 1/2" PVC pipe to bridge the two side rear mounts. Holes are for #8 5/8" length countersunk head sheetmetal screws (They work okay in plastic). For the forward mounts, just trim the headliner trim of the sunroof for the width of the mount (not shown). If you don't have a sunroof, use a bungee cord between the two rear pass "oh sh*t" handles. If you have light action trout or fly rods, the bungee cord maybe necessary as well as the forward hooks. I'm not sure how much weight the snaps for the rear trim can hold, so I would not recommend putting in fully equipped ocean setups.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed