Door Trim Clips
Use the built-in measurement tool to verify fit before downloading or ordering.
Description
These are the clips needed to put the stock door trim to the door. Print 2 of the ends and washers portions and 1 of the center pieces (short might be a tighter fit). I suggest 100% infill and print these sideways for structural rigidity. Washer goes inside the door and the rest clips into the trim like factory.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Loading pricing...
Use the built-in measurement tool to verify fit before downloading or ordering.
Part Description
These are the clips needed to put the stock door trim to the door. Print 2 of the ends and washers portions and 1 of the center pieces (short might be a tighter fit). I suggest 100% infill and print these sideways for structural rigidity. Washer goes inside the door and the rest clips into the trim like factory.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Door Trim Clips
1996-2000 Toyota Mark Ii / Chaser / Cresta JZX100
by protomor
May 9, 2026
Loading pricing...