Dash Trim Tab
1997 Ford F-350 OBS
Description
The small trim pieces on my 1997 OBS Ford F350 broke off (see pictures), so I modeled some insert tabs to replace them so I could re-attach my trim piece. If you can use them, enjoy. PLEASE NOTE: I turned the piece on it's side to slice. This allowed me to avoid using any supports AND if you think about the directionality of the layers, it's stronger on it's side as opposed to vertically.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
The small trim pieces on my 1997 OBS Ford F350 broke off (see pictures), so I modeled some insert tabs to replace them so I could re-attach my trim piece. If you can use them, enjoy. PLEASE NOTE: I turned the piece on it's side to slice. This allowed me to avoid using any supports AND if you think about the directionality of the layers, it's stronger on it's side as opposed to vertically.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed