Switch Panel
1997-2001 Jeep Cherokee XJ
Description
I made this by measuring everything from the original panel on my brothers jeep, after a few hours (and a few test prints) I have a functional panel that can hold six OE switches and one car charger thing. Rocker switches do not seem to fit through the console plastic that goes over this piece. If you do make this please post pictures of it installed to give me ideas on how I could improve it. Also so I can see the jeeps (: *New* Forgot about this since I dont use thingiverse often but since Chpj2017 remixed it I thought it would be nice to put up the end result of this project. I dont remember what I changed but the new files are called finished model and the "oe" and "adapter" files are for my solution to rocker switches, rocker switch gets placed into the adapter then its a very tight fit into the "oe" which gets clicked into the regular switch slot. It worked well enough that I didnt have to modify my dash but it does seem silly to have a switch stick out so far.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I made this by measuring everything from the original panel on my brothers jeep, after a few hours (and a few test prints) I have a functional panel that can hold six OE switches and one car charger thing. Rocker switches do not seem to fit through the console plastic that goes over this piece. If you do make this please post pictures of it installed to give me ideas on how I could improve it. Also so I can see the jeeps (: *New* Forgot about this since I dont use thingiverse often but since Chpj2017 remixed it I thought it would be nice to put up the end result of this project. I dont remember what I changed but the new files are called finished model and the "oe" and "adapter" files are for my solution to rocker switches, rocker switch gets placed into the adapter then its a very tight fit into the "oe" which gets clicked into the regular switch slot. It worked well enough that I didnt have to modify my dash but it does seem silly to have a switch stick out so far.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed