Soft Top Anti-flutter Bow Clip
1997-2006 Jeep Wrangler TJ
Description
A bow to stop flutter when traveling down the freeway. I printed in PET with lots of sells and infill for strength. I printed on its side with supports for max strength. I used 1"x1/8 Aluminum 4 foot stock from my local hardware store. I trimmed it down in length until I had the tension I wanted. I also added a bit of foam to the top. The bow just clips onto the rods above doors, and can be unclipped as needed. Note: I printed my test pieces in clear PLA to help check for fitment and spot any cracking.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
A bow to stop flutter when traveling down the freeway. I printed in PET with lots of sells and infill for strength. I printed on its side with supports for max strength. I used 1"x1/8 Aluminum 4 foot stock from my local hardware store. I trimmed it down in length until I had the tension I wanted. I also added a bit of foam to the top. The bow just clips onto the rods above doors, and can be unclipped as needed. Note: I printed my test pieces in clear PLA to help check for fitment and spot any cracking.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed