Cabin Air Filter Adapter
1997-2001 Toyota Camry XV20
Description
Toyota Camry/Camry Gracia XV20 and Mark II Qualis SXV/MCV20 Japan cabin air filter I adapted the original model for JDM right-hand drive vehicles. The mounting hole shape is slightly different on these vehicles, but that's not a big deal. This adapter is installed using sealant, which will seal any gaps. The model is optimized for minimal use of supports; it is sufficient to specify a support angle greater than 80 degrees. The two-piece version is less than 170 mm wide. The second, two-piece version has additional corner adhesion points for those whose corners tend to peel off. And the one-piece version is for those lucky enough to own a printer with a print area of 300 mm or larger. The filter used is from a Hyundai i20 KIA/HYUNDAI 971331J000 IMPORTANT! Models may be oriented incorrectly. The model should be printed in the position it will be in the car, with the filter space at the top. When modeling, I use a comfortable surface and don't control the top and bottom positions.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Toyota Camry/Camry Gracia XV20 and Mark II Qualis SXV/MCV20 Japan cabin air filter I adapted the original model for JDM right-hand drive vehicles. The mounting hole shape is slightly different on these vehicles, but that's not a big deal. This adapter is installed using sealant, which will seal any gaps. The model is optimized for minimal use of supports; it is sufficient to specify a support angle greater than 80 degrees. The two-piece version is less than 170 mm wide. The second, two-piece version has additional corner adhesion points for those whose corners tend to peel off. And the one-piece version is for those lucky enough to own a printer with a print area of 300 mm or larger. The filter used is from a Hyundai i20 KIA/HYUNDAI 971331J000 IMPORTANT! Models may be oriented incorrectly. The model should be printed in the position it will be in the car, with the filter space at the top. When modeling, I use a comfortable surface and don't control the top and bottom positions.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed