Sill Drain Fitting
1998-2006 Audi Tt 8N
Description
I created this drain fitting as most of the fittings on my TT where either broken or missing. It is not an exact replica (beyond my skill set) but works/fits well. No supports needed, 0.1 layer height. I have only experience in printing in PLA, I believe ABS is better suited to automotive parts due to the effects of heat but as these are fitted to the underside of the car they are unlikely to suffer from high temperatures. Good luck and I hope you find this useful
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I created this drain fitting as most of the fittings on my TT where either broken or missing. It is not an exact replica (beyond my skill set) but works/fits well. No supports needed, 0.1 layer height. I have only experience in printing in PLA, I believe ABS is better suited to automotive parts due to the effects of heat but as these are fitted to the underside of the car they are unlikely to suffer from high temperatures. Good luck and I hope you find this useful
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed