Sun Visor Clip
1998 Mazda 121
Description
The sun visor on my jellybean (98' mazda 121) broke so I designed a quick replacement, it fits quite firm but not too much so, if it's a little too tight for your liking you can heat it up with a heat gun and bend the hook up slightly, or just remix it. Hopefully this helps someone, may also fit other mazdas (or other cars). I printed it in PLA which will hopfully not warp too much during summer, though I'm in Australia and the car is in direct sun (usually 40+ degrees in summer) and we're headed into summer so time will tell. If you're curious if PLA will hold up just leave a comment and I'll reply with how it went. As I always do I included the step file and fusion file.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
The sun visor on my jellybean (98' mazda 121) broke so I designed a quick replacement, it fits quite firm but not too much so, if it's a little too tight for your liking you can heat it up with a heat gun and bend the hook up slightly, or just remix it. Hopefully this helps someone, may also fit other mazdas (or other cars). I printed it in PLA which will hopfully not warp too much during summer, though I'm in Australia and the car is in direct sun (usually 40+ degrees in summer) and we're headed into summer so time will tell. If you're curious if PLA will hold up just leave a comment and I'll reply with how it went. As I always do I included the step file and fusion file.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed