Door Card Spacers
1998-2005 Mazda Mx-5 NB
Description
These spacers were originally designed for use with Primer3D aftermarket door panels on a Mazda NB MX5/Miata/Roadster because the gaps between the bottom of the panel and the door's OEM door-clip holes are too big for the OEM door-clips to lock in place. I originally designed one-piece spacers but the flexible pin that locks into the door would break after 2 or 3 insert/remove cycles. My solution was to create a spacer that the OEM nylon door-clips lock into and survive multiple insert/remove cycles. This eliminates the weak-link in one-piece 3D-printed solutions. The spacers will work with any OEM door clip that has a base diameter of 15mm.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
These spacers were originally designed for use with Primer3D aftermarket door panels on a Mazda NB MX5/Miata/Roadster because the gaps between the bottom of the panel and the door's OEM door-clip holes are too big for the OEM door-clips to lock in place. I originally designed one-piece spacers but the flexible pin that locks into the door would break after 2 or 3 insert/remove cycles. My solution was to create a spacer that the OEM nylon door-clips lock into and survive multiple insert/remove cycles. This eliminates the weak-link in one-piece 3D-printed solutions. The spacers will work with any OEM door clip that has a base diameter of 15mm.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed