Wind Deflector Mounting Grommets
1998-2003 Saab 9-3 OG (Convertible)
Description
These grommets replace the stock ones on the first generation Saab 9-3 convertible. When the wind deflector is installed, it has 2 pins that insert into holes in the interior rear side panels. When the interior was redone on my car, the plastic grommets that lined these holes were lost / broken, so I designed 3D-printable replacements. Unlike the originals, these do not require any installation hardware, they just clip into the holes.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
These grommets replace the stock ones on the first generation Saab 9-3 convertible. When the wind deflector is installed, it has 2 pins that insert into holes in the interior rear side panels. When the interior was redone on my car, the plastic grommets that lined these holes were lost / broken, so I designed 3D-printable replacements. Unlike the originals, these do not require any installation hardware, they just clip into the holes.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed