Hood Support Rod Latch Clip
1998 Subaru Legacy (Outback)
May 6, 2026
Use the built-in measurement tool to verify fit before downloading or ordering.
Description
The clip that holds the hood support rod in the stowed position was broken on the 98 Subaru Legacy Outback. PLA would likely melt in the engine bay, so I printed in ABS. Pictured item was printed with a 0.8mm nozzle.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Loading pricing...
Use the built-in measurement tool to verify fit before downloading or ordering.
Part Description
The clip that holds the hood support rod in the stowed position was broken on the 98 Subaru Legacy Outback. PLA would likely melt in the engine bay, so I printed in ABS. Pictured item was printed with a 0.8mm nozzle.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed