Rear Cup Holder Arm
1998-2000 Toyota Corolla
May 9, 2026
Use the built-in measurement tool to verify fit before downloading or ordering.
Description
The cup holder arm broke on a friends 99 Toyota Corolla rear cup holder. This is a super cheezy replacement. I'm new to 3d modeling, so it isn't clean at all, but it does work. The stock arm used springs on either side, but this one doesn't use the spring. You just pull it up when you want to use it. Hope it proves useful.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Loading pricing...
Use the built-in measurement tool to verify fit before downloading or ordering.
Part Description
The cup holder arm broke on a friends 99 Toyota Corolla rear cup holder. This is a super cheezy replacement. I'm new to 3d modeling, so it isn't clean at all, but it does work. The stock arm used springs on either side, but this one doesn't use the spring. You just pull it up when you want to use it. Hope it proves useful.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed