Door Speaker Mount
1999-2003 Subaru Outback BH
Description
I recently blew the door speakers in my Australian 2003 Subaru Outback wagon only to find i needed to make a mount to allow the fitment of new aftermarket speakers. The following STLs will fit the three-point fitment holes in BH Outbacks 1999-2003. You'll need to print two rear and one of each front as they are angled. The door skins will fit perfectly over the mounts no problem. I printed mine in PolyMaxx at 75% infill as I wanted something solid to screw the speakers to, but that may have been overkill. No supports required. I also suggest some sort of stick on foam strip like door sealer on the face that touches the door to prevent rattles and make a better seal for bass.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I recently blew the door speakers in my Australian 2003 Subaru Outback wagon only to find i needed to make a mount to allow the fitment of new aftermarket speakers. The following STLs will fit the three-point fitment holes in BH Outbacks 1999-2003. You'll need to print two rear and one of each front as they are angled. The door skins will fit perfectly over the mounts no problem. I printed mine in PolyMaxx at 75% infill as I wanted something solid to screw the speakers to, but that may have been overkill. No supports required. I also suggest some sort of stick on foam strip like door sealer on the face that touches the door to prevent rattles and make a better seal for bass.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed