Wiper Fluid Cap
2000 Honda Cr-v
May 5, 2026
Use the built-in measurement tool to verify fit before downloading or ordering.
Description
The Wiper Fluid Cap on my 2000 Honda CRV finally cracked and fell off, so I used the freeware version of eMachineShop to design a replacement. The Wiper Fluid Cap has a center hole in it so you can zip tie it to the long plastic piece that slides down into the Wiper Fluid Storage Tank. I printed the cap in PETG and so far it is holding up pretty well.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Loading pricing...
Use the built-in measurement tool to verify fit before downloading or ordering.
Part Description
The Wiper Fluid Cap on my 2000 Honda CRV finally cracked and fell off, so I used the freeware version of eMachineShop to design a replacement. The Wiper Fluid Cap has a center hole in it so you can zip tie it to the long plastic piece that slides down into the Wiper Fluid Storage Tank. I printed the cap in PETG and so far it is holding up pretty well.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed