Door Lock Pivot Snap
2000 Honda Civic
Description
Our 2000 Honda Civic rear door would not open from outside. Took panel off and saw the pivot snap was broken, so I took measurements and made a replacement part. If this one breaks in same place I will re-design to include a harness. Initial tests are encouraging. I made this out of 3D-Fuel APLA+ 1.75, 205 Extrusion temp and 60 Bed temp. 4mm nozzle on a Monoprice Mini Select v2 printer.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Our 2000 Honda Civic rear door would not open from outside. Took panel off and saw the pivot snap was broken, so I took measurements and made a replacement part. If this one breaks in same place I will re-design to include a harness. Initial tests are encouraging. I made this out of 3D-Fuel APLA+ 1.75, 205 Extrusion temp and 60 Bed temp. 4mm nozzle on a Monoprice Mini Select v2 printer.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed