Hood Prop Clip
Description
Model for the engine lid prop clip that always breaks on MR2 Spyders (apparently its used on lots of other Toyotas too, the part number is TOY-90959-01136). I'm selling prints of these on Spyderchat.com if you don't have access to a 3D printer. My username there is Saab_Story. Designed in Tinkercad The print was a little large when I printed it, so a very small amount of sanding may need to be done to get the dimension of the short side in tolerance.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Model for the engine lid prop clip that always breaks on MR2 Spyders (apparently its used on lots of other Toyotas too, the part number is TOY-90959-01136). I'm selling prints of these on Spyderchat.com if you don't have access to a 3D printer. My username there is Saab_Story. Designed in Tinkercad The print was a little large when I printed it, so a very small amount of sanding may need to be done to get the dimension of the short side in tolerance.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed