Rear Tow Hook Cover Cap
2000-2002 Toyota Mr2 Spyder ZZW30
Description
This is a replacement tow-hook cover for the Toyota MR2 Spyder (MR-S) gen-1 ZZW30 model (2000-2002). It may fit the gen-2 ZZW30 (2002+), but I haven't tried. It's been 3D-modelled on Solidworks from scratch by measuring the original part. It has a different fit and clipping mechanism to the original part. It is intended to be able to taken on & off without a screw driver, it has a matching handle, parallel to the horizontal features on the rear bumper trim. It doesn't have the tether. You can probably create a tether by drilling a hole and use of cable ties. It has lettering "LEFT", so if you can read it, then it's Left side. The Right side is simply mirrored. Print 100% filled. No support required if the flat face is down.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is a replacement tow-hook cover for the Toyota MR2 Spyder (MR-S) gen-1 ZZW30 model (2000-2002). It may fit the gen-2 ZZW30 (2002+), but I haven't tried. It's been 3D-modelled on Solidworks from scratch by measuring the original part. It has a different fit and clipping mechanism to the original part. It is intended to be able to taken on & off without a screw driver, it has a matching handle, parallel to the horizontal features on the rear bumper trim. It doesn't have the tether. You can probably create a tether by drilling a hole and use of cable ties. It has lettering "LEFT", so if you can read it, then it's Left side. The Right side is simply mirrored. Print 100% filled. No support required if the flat face is down.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed