Support Rod Retainer
2000-2007 Toyota Mr2 Spyder ZZW30
Description
works the same as this: https://www.thingiverse.com/thing:2633948 for TOYOTA MRS/MR2 spyder ZZW30 I tried his model and it cracked when tried to put the rod in (thx for sharing btw), so I created mine. it's a lot more flexible so it doesn't crack that easily:) Print flat side down, 100 fill and thick wall. check the layers all material should be printed as "WALL" (no zigzags) rod diameter: 8mm chassis cutout size: 11.4 x 7mm
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
works the same as this: https://www.thingiverse.com/thing:2633948 for TOYOTA MRS/MR2 spyder ZZW30 I tried his model and it cracked when tried to put the rod in (thx for sharing btw), so I created mine. it's a lot more flexible so it doesn't crack that easily:) Print flat side down, 100 fill and thick wall. check the layers all material should be printed as "WALL" (no zigzags) rod diameter: 8mm chassis cutout size: 11.4 x 7mm
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed