Trunk Shade End Cap
2001 Audi A6 Allroad C5
Description
Ending cap for Audi Allroad A6 C5 2001 trunk shade. Original made with PA after 20 years just broke down. This version is WIP but it works already. I plan to make other side with the spring mount point. Print time about 8 hours so if you don't need it wait till the final version :) EDIT: I have added the other element (left side). To assembly You will need a piece of wire (3mm diameter). I am planning to add a little hooks for the left side to keep the element at place. PS: Uploaded for everyone who were looking for this part. ;)
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Ending cap for Audi Allroad A6 C5 2001 trunk shade. Original made with PA after 20 years just broke down. This version is WIP but it works already. I plan to make other side with the spring mount point. Print time about 8 hours so if you don't need it wait till the final version :) EDIT: I have added the other element (left side). To assembly You will need a piece of wire (3mm diameter). I am planning to add a little hooks for the left side to keep the element at place. PS: Uploaded for everyone who were looking for this part. ;)
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed