Fog Light Air Inlet Adapter
2001-2005 Lexus Is300
Description
Adapts the unused air inlet next to the fog lights to a hose. It mounts to the bumper via a unused tab on the top of the inlet. There is a version for 1'" hose and a version for 2" hose. There are 2 major versions. One version has the holes and slots for bumper modeled. The version with "Spiral" in the name is meant for vase mode/spiral printing. V1.6 should fit better than V1.5. The width of the inlet was increased by 2mm in V1.6. Test prints were printed in ASA with a 2mm wall in vase mode with 0.5mm layer heights.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Adapts the unused air inlet next to the fog lights to a hose. It mounts to the bumper via a unused tab on the top of the inlet. There is a version for 1'" hose and a version for 2" hose. There are 2 major versions. One version has the holes and slots for bumper modeled. The version with "Spiral" in the name is meant for vase mode/spiral printing. V1.6 should fit better than V1.5. The width of the inlet was increased by 2mm in V1.6. Test prints were printed in ASA with a 2mm wall in vase mode with 0.5mm layer heights.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed