Cup Holder
2001 Peugeot 306 (Break)
Description
Was looking for a cup holder for my Peugeot 306 Break 2001 but haven't found any that fits my needs so I designed this one in Fusion360. The holes on the actual "cup" of the print are there just to reduce time and plastic used on this print because without any holes it would be just under 100gr. I made another one with more holes but sadly I'm almost out of filament so I did print it. If you don't want to make holes in your car interior like I did I guess you could use hot glue or something like that because the hinge part is a very tight fit to the car.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Was looking for a cup holder for my Peugeot 306 Break 2001 but haven't found any that fits my needs so I designed this one in Fusion360. The holes on the actual "cup" of the print are there just to reduce time and plastic used on this print because without any holes it would be just under 100gr. I made another one with more holes but sadly I'm almost out of filament so I did print it. If you don't want to make holes in your car interior like I did I guess you could use hot glue or something like that because the hinge part is a very tight fit to the car.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed