Hood Prop Rod Holder
2001 Seat Cordoba/ibiza (1.9 SDI)
Description
I designed a simple hood arm holder for my gf's Seat Cordoba 1.9 sdi 2001. The fitting is a rectangle of 8x7.20 mm in my case (because it was rusty and worn). I upload the .prt file so everyone can tweak with the design. I printed it with supports on the cube, 0.2 layer height with PETG, no issues. Due to being a little piece, dial your speed settings so the supports and the cube (that is rotated 15º degrees) are well printed. Enjoy and give your feedback!
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I designed a simple hood arm holder for my gf's Seat Cordoba 1.9 sdi 2001. The fitting is a rectangle of 8x7.20 mm in my case (because it was rusty and worn). I upload the .prt file so everyone can tweak with the design. I printed it with supports on the cube, 0.2 layer height with PETG, no issues. Due to being a little piece, dial your speed settings so the supports and the cube (that is rotated 15º degrees) are well printed. Enjoy and give your feedback!
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed