Door Unlock Rod Clip
2001 Toyota 4runner 3rd Gen
Description
This clip holds the rod that allows the key to unlock the passenger door on my 2001 4Runner. It probably works for many more vehicles. The bore diameter (clearance for the rod) is around 3.9mm. So take that into consideration if you decide to use this. I personally printed them with the C up. This is not ideal, but seems functional. Ideally the layer direction would be perpendicular to all the snaps. I recommend support for the gland end to prevent drooping or warping. Also clean it up with a razor after wards to allow the tight snap fit to work well.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This clip holds the rod that allows the key to unlock the passenger door on my 2001 4Runner. It probably works for many more vehicles. The bore diameter (clearance for the rod) is around 3.9mm. So take that into consideration if you decide to use this. I personally printed them with the C up. This is not ideal, but seems functional. Ideally the layer direction would be perpendicular to all the snaps. I recommend support for the gland end to prevent drooping or warping. Also clean it up with a razor after wards to allow the tight snap fit to work well.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed