Rear Bumper End Cap
2002 Jeep Wrangler TJ
Description
Remix of 2340538 I created a tapered endcap from this original design. It fits well in the rear bumper of my 2002 Jeep TJ. I need to lengthen and increase the thickness around the bolt holes. Printed in PLA PRO. I will update it. I included the test fit one as it prints in less time. Print as downloaded for left side, reverse in CURA for right side. I rotate to largest flat side to print, with supports and brim
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Remix of 2340538 I created a tapered endcap from this original design. It fits well in the rear bumper of my 2002 Jeep TJ. I need to lengthen and increase the thickness around the bolt holes. Printed in PLA PRO. I will update it. I included the test fit one as it prints in less time. Print as downloaded for left side, reverse in CURA for right side. I rotate to largest flat side to print, with supports and brim
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed