Dash Gauge Pod
2002-2007 Subaru Impreza Newage
Description
This is my attempt at creating a 3 gauge dash pod to replace the clock on a 2002-2007 Subaru Impreza I've uploaded both 52 and 60mm the 60mm includes holes for mounting within gaps on the dash pad with screws and clips, and the alarm led - use the holes as a guide as they are slightly undersized to drill out for final placement, the front 2 seem about right and rear I would suggest opening up the holes towards the center of the pod. I Strongly recommend ASA or ABS as the heat with warp PETG in summer I used m3x30 screws with the clips and washers to neaten the install You will likely need to sand down all the gauge holes as they too are a very snug fit on my printer and need a dremel after paint Final print in first pic, I'm very happy with the fit!
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is my attempt at creating a 3 gauge dash pod to replace the clock on a 2002-2007 Subaru Impreza I've uploaded both 52 and 60mm the 60mm includes holes for mounting within gaps on the dash pad with screws and clips, and the alarm led - use the holes as a guide as they are slightly undersized to drill out for final placement, the front 2 seem about right and rear I would suggest opening up the holes towards the center of the pod. I Strongly recommend ASA or ABS as the heat with warp PETG in summer I used m3x30 screws with the clips and washers to neaten the install You will likely need to sand down all the gauge holes as they too are a very snug fit on my printer and need a dremel after paint Final print in first pic, I'm very happy with the fit!
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed