Hood Spacer Block
2003 Subaru Impreza (WRX)
Description
This is basically a hood riser to allow for clearance and airflow. I designed this specifically for use on my 2003 Impreza wrx because my blow off valve was hitting the hood and I wanted some venting to keep my engine bay/intake temps down. The spacer is 19mm tall, 99mm long, and 24mm wide. The holes from center to center are at 75mm with extra clearance on both sides for adjustment. The holes are for 12mm bolts. Print in abs, pla, or tpu. Make infill solid or close to it. No supports.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is basically a hood riser to allow for clearance and airflow. I designed this specifically for use on my 2003 Impreza wrx because my blow off valve was hitting the hood and I wanted some venting to keep my engine bay/intake temps down. The spacer is 19mm tall, 99mm long, and 24mm wide. The holes from center to center are at 75mm with extra clearance on both sides for adjustment. The holes are for 12mm bolts. Print in abs, pla, or tpu. Make infill solid or close to it. No supports.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed