Cup Holder
2003-2009 Toyota 4runner N210
May 7, 2026
Use the built-in measurement tool to verify fit before downloading or ordering.
Description
I was tired of the cup holder in my 4th gen 4Runner so I took some measurements and estimated the general shape of the cup holder opening. My print ran out of filament at the end but worked as is, so the actual model might be a little tall. Printed upside down so no supports needed.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Loading pricing...
Use the built-in measurement tool to verify fit before downloading or ordering.
Part Description
I was tired of the cup holder in my 4th gen 4Runner so I took some measurements and estimated the general shape of the cup holder opening. My print ran out of filament at the end but worked as is, so the actual model might be a little tall. Printed upside down so no supports needed.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed