52mm Gauge Holder
2003-2009 Volkswagen Golf MK5
May 5, 2026
Use the built-in measurement tool to verify fit before downloading or ordering.
Description
This Thing is an Gauge Holder for 52mm Gauges! so every common Aftermarket Gauge fits! its specificly for the Golf MK5 Airoutlet on the left side (probably fits the right site too) You just replace the original fins with this piece and you are ready to go. Dont print it in PLA, ABS only!! because of the heat in the car on warm Summerdays PLA deforms.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Loading pricing...
Use the built-in measurement tool to verify fit before downloading or ordering.
Part Description
This Thing is an Gauge Holder for 52mm Gauges! so every common Aftermarket Gauge fits! its specificly for the Golf MK5 Airoutlet on the left side (probably fits the right site too) You just replace the original fins with this piece and you are ready to go. Dont print it in PLA, ABS only!! because of the heat in the car on warm Summerdays PLA deforms.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed