I couldn't find a 3D model of the early model 350Z Windshield Wiper Fluid Reservoir Cap so I took some measurements and based the design on this [link](https://www.z1motorsports.com/windshield-washer/nissan/oem-350z-g35-windshield-washer-reservoir-cap-03-06-p-5557.html). Should fit any other car that uses either 28913-JX00A or 28913-AM600. It's a rather exact fit, so depending on your printer settings it may need +/- a few percent scale adjustment. Printing as is with PETG at 240C with .3mm layer height worked well and snapped on nicely. 4 models to choose from appropriately named.
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
I couldn't find a 3D model of the early model 350Z Windshield Wiper Fluid Reservoir Cap so I took some measurements and based the design on this [link](https://www.z1motorsports.com/windshield-washer/nissan/oem-350z-g35-windshield-washer-reservoir-cap-03-06-p-5557.html). Should fit any other car that uses either 28913-JX00A or 28913-AM600. It's a rather exact fit, so depending on your printer settings it may need +/- a few percent scale adjustment. Printing as is with PETG at 240C with .3mm layer height worked well and snapped on nicely. 4 models to choose from appropriately named.
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed