Subwoofer Mount
2004-2006 Chevrolet Avalanche
Description
This is likely going to be an incredibly niche thing, but since I designed it I'm posting it. I replaced the center console in my 2004 Chevrolet Avalanche with a jump seat, but this meant that I had to put the stock subwoofer in a different location. I designed this mount that connects to the rear air redirect box since I no longer had rear seating air anyways. It's a very awkward fit to get the OEM screws into the subwoofer mount and onto the airbox but once you do get them in it mounts pretty sturdy. You'll need to keep the front cover that comes on the subwoofer inside the center console, and you'll also need some nuts and bolts to attach the mount to the subwoofer itself. Hole placement is a little off unfortunately, so you may have to do a little bit of drilling. Recommend printing in ABS since it gets hot inside the truck in the summer. Print is also very awkward so I recommend a brim and supports.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is likely going to be an incredibly niche thing, but since I designed it I'm posting it. I replaced the center console in my 2004 Chevrolet Avalanche with a jump seat, but this meant that I had to put the stock subwoofer in a different location. I designed this mount that connects to the rear air redirect box since I no longer had rear seating air anyways. It's a very awkward fit to get the OEM screws into the subwoofer mount and onto the airbox but once you do get them in it mounts pretty sturdy. You'll need to keep the front cover that comes on the subwoofer inside the center console, and you'll also need some nuts and bolts to attach the mount to the subwoofer itself. Hole placement is a little off unfortunately, so you may have to do a little bit of drilling. Recommend printing in ABS since it gets hot inside the truck in the summer. Print is also very awkward so I recommend a brim and supports.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed