Front Bumper License Plate Cap Insert
2004 Honda Cr-v
Description
Missing one and decided to mirror it and replace both license plate caps These can be installed with epoxy or caulk. I designed them to use rust proof 1-inch sheet-rock screws to spread the small plug. I ground the pointy tip off of the screw, just in case the bumper skin is pushed back far enough to touch the AC condenser... but if it ends up that far back you have bigger problems. You might want to scale these down by 1% or 2% for a better fit... depending on the material and printer you use.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Missing one and decided to mirror it and replace both license plate caps These can be installed with epoxy or caulk. I designed them to use rust proof 1-inch sheet-rock screws to spread the small plug. I ground the pointy tip off of the screw, just in case the bumper skin is pushed back far enough to touch the AC condenser... but if it ends up that far back you have bigger problems. You might want to scale these down by 1% or 2% for a better fit... depending on the material and printer you use.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed