Tail Light Clip Holder Bracket
2004 Hyundai Santa Fe SM
Description
This is the plastic clip from the tail light of Hyundai Santa Fe SM (2004). The small piece breaks easily when removing the light assembly, so I made a new one. This one is for the right side of the vehicle. However, a simple mirroring will give you the left side. I printed it in ABS at 10 lines (which already gives 100% infill), with support structures and brim (1 hour print time at 0.1 mm resolution).
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is the plastic clip from the tail light of Hyundai Santa Fe SM (2004). The small piece breaks easily when removing the light assembly, so I made a new one. This one is for the right side of the vehicle. However, a simple mirroring will give you the left side. I printed it in ABS at 10 lines (which already gives 100% infill), with support structures and brim (1 hour print time at 0.1 mm resolution).
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed