Hvac Knob
2004 Toyota Tacoma
May 7, 2026
Use the built-in measurement tool to verify fit before downloading or ordering.
Description
The only print issue i had was 1 or 2 popped off the bed very early. I ran the bed heat up to about 84 and then i slowed my speed down to 85 will printing the shaft and it stuck very well. I also cleaned bed with acetone. that may have been all that was needed but anyway that is what worked for me. Feel free to edit or remake file however you want.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Loading pricing...
Use the built-in measurement tool to verify fit before downloading or ordering.
Part Description
The only print issue i had was 1 or 2 popped off the bed very early. I ran the bed heat up to about 84 and then i slowed my speed down to 85 will printing the shaft and it stuck very well. I also cleaned bed with acetone. that may have been all that was needed but anyway that is what worked for me. Feel free to edit or remake file however you want.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed