Dash Panel Fastener
2005 Bmw 3 Series E46 (Sedan)
Description
Designed this "bolt" for my BMW E46 Sedan 2005 and it fits like a glove. Printing: Whatever really, I used a Flashforge Adventure 3 and used the standard settings but chose the low (fast) selection since it started as a prototype but it worked out just fine the way it was. But would I print this today, almost 3 years later, I would make it 80 - 100% infill and likely use ABS. Used PLA Feel free to use however you wish, made by me.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Designed this "bolt" for my BMW E46 Sedan 2005 and it fits like a glove. Printing: Whatever really, I used a Flashforge Adventure 3 and used the standard settings but chose the low (fast) selection since it started as a prototype but it worked out just fine the way it was. But would I print this today, almost 3 years later, I would make it 80 - 100% infill and likely use ABS. Used PLA Feel free to use however you wish, made by me.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed