Cubby Gauge Pod
2005 Chevrolet Silverado 2500
Description
This is a gauge pod I designed for my 2005 Silverado 2500. It's the cubby just below the center dash vent. Not on all Silverado's though. Once you remove the old cubby, you need to remove the old clips which can be a pain. But are necessary to a good fitment in your truck. Replaces GM15766229 Cubby so check to see if this looks like yours. Gauge is a 2" and hole in center of part is angled to fit with the angled bezel. ( I am using a GlowShift and it fits perfectly with the bezel included with the gauge)
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is a gauge pod I designed for my 2005 Silverado 2500. It's the cubby just below the center dash vent. Not on all Silverado's though. Once you remove the old cubby, you need to remove the old clips which can be a pain. But are necessary to a good fitment in your truck. Replaces GM15766229 Cubby so check to see if this looks like yours. Gauge is a 2" and hole in center of part is angled to fit with the angled bezel. ( I am using a GlowShift and it fits perfectly with the bezel included with the gauge)
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed