Tweeter Speaker Bracket
2005-2015 Toyota Tacoma 2nd Gen
May 9, 2026
Use the built-in measurement tool to verify fit before downloading or ordering.
Description
Made to fit skar tws01 tweeter speaker for 2nd gen tacomas. It fits a bit tight so if your printer settings are not dialed in perfect the speaker hole will be undersized. Recommend printing at 100% with high heat tolerance material and a filament with little to no creep. Hole is approximately 1.85in diameter.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Loading pricing...
Use the built-in measurement tool to verify fit before downloading or ordering.
Part Description
Made to fit skar tws01 tweeter speaker for 2nd gen tacomas. It fits a bit tight so if your printer settings are not dialed in perfect the speaker hole will be undersized. Recommend printing at 100% with high heat tolerance material and a filament with little to no creep. Hole is approximately 1.85in diameter.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed