Rear Wiper Attachment
2005-2011 Toyota Yaris
Description
my windshield wiper clip was snapped due to heavy snowfall. To replace the part, you will need to saw off the end of the wiper arm with the bad clip, insert the part (preferably printed in PETG, nylon, or ABS), and secure it with 4-6 M3 screws ( you can use M2 screws with threaded inserts aswell). Then just install it on the car goes well with this: https://www.thingiverse.com/thing:4949898
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
my windshield wiper clip was snapped due to heavy snowfall. To replace the part, you will need to saw off the end of the wiper arm with the bad clip, insert the part (preferably printed in PETG, nylon, or ABS), and secure it with 4-6 M3 screws ( you can use M2 screws with threaded inserts aswell). Then just install it on the car goes well with this: https://www.thingiverse.com/thing:4949898
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed