I created this because the original 350Z Bose speakers had a mount that was built into the speaker. The JBL door speakers needed to be mounted about 3cm from the door (they were too recessed) or the window would hit the magnet of the speaker and would not roll down all the way.
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
I created this because the original 350Z Bose speakers had a mount that was built into the speaker. The JBL door speakers needed to be mounted about 3cm from the door (they were too recessed) or the window would hit the magnet of the speaker and would not roll down all the way.
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed