Dash Trim Clip
2006 Hyundai Sonata
Description
I recently swapped out the radio in my 2006 Hyundai Sonata, and in the process I discovered that there are a bunch of clips that hold the dash trim in place. These clips seem to have a tendency to get lost inside the vehicle, so I made a rough replacement part. I ended up using several when I was putting everything back together, they seem to work well enough although I believe they make for a slightly tighter fit than the original clips. Hopefully these come in handy for someone else! From what I can gather these clips are used on Hyundai vehicles from other years and in other models too - so maybe someone else will be after one someday. I'd recommend printing with a small nozzle - 0.4mm or below. I printed mine with a 0.8mm nozzle, and they didn't exactly come out pretty - but they did work, so close enough.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I recently swapped out the radio in my 2006 Hyundai Sonata, and in the process I discovered that there are a bunch of clips that hold the dash trim in place. These clips seem to have a tendency to get lost inside the vehicle, so I made a rough replacement part. I ended up using several when I was putting everything back together, they seem to work well enough although I believe they make for a slightly tighter fit than the original clips. Hopefully these come in handy for someone else! From what I can gather these clips are used on Hyundai vehicles from other years and in other models too - so maybe someone else will be after one someday. I'd recommend printing with a small nozzle - 0.4mm or below. I printed mine with a 0.8mm nozzle, and they didn't exactly come out pretty - but they did work, so close enough.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed