Boot Trim And Reversing Camera Mount
2006-2015 Mazda Mx-5 Miata NC
Description
I replicated the blank piece of trim on the boot of my NC that contains the keyless entry sensor on some later models. I've included the blank piece so that you can add your own camera mount. It clips in-place just like the original but you may find it hard to remove without breaking the print if you've used PLA. There's a second file containing the mount that I used with a 'Car Rover CA009M' from Amazon - https://www.amazon.co.uk/dp/B013AUMV12/
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I replicated the blank piece of trim on the boot of my NC that contains the keyless entry sensor on some later models. I've included the blank piece so that you can add your own camera mount. It clips in-place just like the original but you may find it hard to remove without breaking the print if you've used PLA. There's a second file containing the mount that I used with a 'Car Rover CA009M' from Amazon - https://www.amazon.co.uk/dp/B013AUMV12/
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed