Rear Speaker Bracket
2006-2008 Mazda Mx-5 Miata NC
Description
Replace your factory rear 3.5" speakers with Aftermarket speakers from Kicker, JL Audio, Rockford Fosgate, etc! The factory speaker mount in the Miata is too small to accept the larger baskets/magnets of most aftermarket speakers, so I made a new one! This bolts right into the factory location, puts the speakers right where they need to be, and allows the plastic covers to go back in place without any obstructions. You may need to cut off a small metal piece on a tab just behind the driver side speaker to get it to fit perfectly (just depends on what aftermarket speakers you go with). I recommend buying some 5 minute epoxy from Walmart for $5. After you're done printing, mix some up and using a cheap acid brush (or similar) apply it to the exterior of the piece to make it as strong as a plastic-injection part by the time you're done.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Replace your factory rear 3.5" speakers with Aftermarket speakers from Kicker, JL Audio, Rockford Fosgate, etc! The factory speaker mount in the Miata is too small to accept the larger baskets/magnets of most aftermarket speakers, so I made a new one! This bolts right into the factory location, puts the speakers right where they need to be, and allows the plastic covers to go back in place without any obstructions. You may need to cut off a small metal piece on a tab just behind the driver side speaker to get it to fit perfectly (just depends on what aftermarket speakers you go with). I recommend buying some 5 minute epoxy from Walmart for $5. After you're done printing, mix some up and using a cheap acid brush (or similar) apply it to the exterior of the piece to make it as strong as a plastic-injection part by the time you're done.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed