Side Indicator Repeater Spacer
2006-2015 Mazda Mx-5 NC
Description
I bought a pair of aftermarket side indicator repeaters for my MX-5 but was unhappy with the fit so designed a spacer to reduce improve the seating and look. I printed mine in PETG with shells and top/base values to make them nearly solid. Fitting instructions: 1) Put a smear of silicone sealant on each face and let it dry to improve grip and keep water out. 2) Remove existing repeaters by sliding in a credit card from the door side of the unit to release the clip and it will pull out. 3) Twist to remove the bulb holder and ensure it doesn't disappear into the car's wing. 4) Slip a printed spacer over the new repeater - Wide gap to the wider part of the repeater. 5) Insert the bulb holder into the repeater and clip it back into the car.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I bought a pair of aftermarket side indicator repeaters for my MX-5 but was unhappy with the fit so designed a spacer to reduce improve the seating and look. I printed mine in PETG with shells and top/base values to make them nearly solid. Fitting instructions: 1) Put a smear of silicone sealant on each face and let it dry to improve grip and keep water out. 2) Remove existing repeaters by sliding in a credit card from the door side of the unit to release the clip and it will pull out. 3) Twist to remove the bulb holder and ensure it doesn't disappear into the car's wing. 4) Slip a printed spacer over the new repeater - Wide gap to the wider part of the repeater. 5) Insert the bulb holder into the repeater and clip it back into the car.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed